Custom Length 4WD Grab Handles Made for Your Setup
Not every 4WD has the same mounting points. A standard grab handle length does not suit every vehicle, canopy, drawer system or custom build.
Krawlergrips specialises in custom length 4WD grab handles. Each handle is measured, braided and finished by hand in Brisbane.
You choose the length. You choose the colours. We make the handle for your setup.
What is a custom length 4WD grab handle?
A custom length grab handle is made to suit the distance between your mounting points and the amount of room you want around your hand.
This helps when:
- Factory mounting points sit further apart
- A standard handle feels too tight
- You want more hand room
- Your canopy or drawer system has unusual mounting points
- You have added your own mounting points
- You need matching handles in different lengths
Krawlergrips makes custom sizes instead of limiting you to one standard measurement.
How do you measure for a custom grab handle?
Measure from the centre of one mounting hole to the centre of the other mounting hole.
Standard lengths are 21cm and 24cm. Custom lengths are available. Contact Krawlergrips with your centre-to-centre screw spacing if you are unsure which length to order.
Where are custom length grab handles used?
Custom sizing suits more than factory grab handle positions.
Krawlergrips makes handles for:
- Nissan Patrols
- Toyota LandCruisers
- Toyota Hiluxes
- Ford Rangers
- Isuzu D-MAXs
- Mitsubishi Tritons
- Mazda BT 50s
- Jeeps
- Custom canopies
- 4WD drawer systems
- Campers and touring vehicles
- Ute trays and storage setups
Your vehicle must have suitable screw mounting points. These handles do not directly replace clip in factory handles.
Choose your custom length and colours · Shop matching colour washers
Shop 21cm and 24cm grab handles · Shop custom-length grab handles · Shop matching colour washers